In this Electronics video tutorial you will learn how to build and use a tinyCylon kit. The kit contains a battery pack, a PCB, LEDs, resistor, a momentary switch and a screw. The long end of the LEDs will go into the square shaped contacts. Don’t push the LEDs right up to the board. Instead, use some poster putty to hold the LEDs standing upright so that they can be bent later on. Fix all the LEDs in this manner and solder them on the other side. Then solder the leads of the battery pack. Switch on the battery and check out the functioning of the kit by the blinking LEDs. Now the tinyCylon kit is assembled. To fix it on a gun, watch the video.
Comments
No Comments Exist
Be the first, drop a comment!